DYNAMIC STABILITY CONTROL (DSC)
Outline
Electrical brake assist control has been adopted, improving safety.
The DSC HU/CM, integrating both the Hydraulic Unit (HU) and Control Module (CM), has been adopted, resulting in a size and weight reduction.
An enhanced malfunction diagnosis system, used with the Mazda Modular Diagnostic System (M-MDS), has been adopted, improving serviceability.
Serviceability improved by the automatic configuration function.
The Hill Launch Assist (HLA) and Tire Pressure Monitoring System (TPMS)* have been adopted, improving safety.
- *
- Vehicles with Tire Pressure Monitoring System (TPMS)
DSC operation outline
The ABS prevents wheel lock-up during braking. The TCS detects drive wheel spin due to loss of traction and controls engine speed to suppress wheel spin. With these systems, safety is assured when driving or stopping.
Additionally, sudden changes in vehicle attitude, due to evasive steering or road conditions, are controlled by the DSC. The DSC suppresses vehicle sideslip when driving due to vehicle spin (oversteer) or drift-out (understeer) by controlling braking and engine speed. At this time, the TCS/DSC indicator light illuminates to alert the driver that the DSC is operating due to a dangerous situation. As a result, the driver can calmly react and is provided leeway for the next maneuver, resulting in safe driving conditions.
In this way the combination of DSC + ABS + TCS ensures driving, stopping and turning safety in all aspects.
Results of DSC operation
CAUTION:
While the DSC is a steering safety system, it does not improve normal steering function. Therefore, always drive carefully, even if the vehicle has DSC, and do not overestimate the DSC capability.
If the initialization procedures for the brake fluid pressure, low-G, and yaw rate sensors are not performed correctly, an incorrectly determined initial point may cause a discrepancy between the actual driving conditions of the vehicle and the signals from the sensors, resulting in improper DSC operation. Therefore, after replacing the following parts, make sure to perform the DSC HU/CM initialization procedures of the sensors with the vehicle stopped on a level ground to insure proper DSC operation. For the initialization procedures of the sensors, refer to the Workshop Manual.
DSC HU/CM
SAS control module
The DSC and ABS will not operate normally under the following conditions:
With tires that are not of the specified size, manufacturer or tread pattern, or not inflated according to specification
With tires that have significant comparative wear variation
With tire chains
With an emergency spare tire
Structural View
Vehicle front side
Vehicle rear side
System wiring diagram
Warning light and indicator light
No. |
Warning light/Indicator light |
Name |
Function |
1 |
Brake system warning light |
|
|
2 |
ABS warning light |
|
|
3 |
TCS/DSC indicator light |
|
|
4 |
DSC OFF indicator light |
|
|
6 |
Electric vacuum pump warning light |
|
Construction
The DSC system consists of the following parts. While each part has a regular function in other systems, only the function during DSC control is listed.
Part name |
Function |
DSC HU/CM |
|
PCM |
|
TCM (AT) |
|
EPS CM |
|
SAS control module |
|
Electric vacuum pump CM |
|
Brake system warning light |
|
DSC OFF switch |
|
TPMS set switch* |
|
TPMS warning light* |
|
ABS wheel-speed sensor |
|
Brake fluid pressure sensor (Built into DSC HU/CM) |
|
- *
- Vehicles with Tire Pressure Monitoring System (TPMS)