Knowledge Base

Free to use workshop manual for your 2015+ Mk4 'ND' Mazda MX-5
Home

 

< Previous   Next >

CRASH ZONE SENSOR [TWO-STEP DEPLOYMENT CONTROL SYSTEM]

Purpose

  • The crash zone sensor detects an impact during a frontal or frontal offset collision to the vehicle.

Function

  • The crash zone sensor converts the detected impact to an electrical signal.

Construction

  • The crash zone sensor is built into the crash sensor.

  • The crash zone sensor is located on the front bumper reinforcement on the back side of the front bumper.

  • Two crash zone sensors are installed for independent impact detection on the left and right.

Operation

Fail-safe

  • Not applicable

< Previous   Next >
 

Free to use workshop manual for your 2015+ Mk4 'ND' Mazda MX-5

COPYRIGHT NOTICE:
This fan site is not affiliated with Mazda, and is intended for personal, or commercial use only. The content of our web pages is for general information purposes only and is presented “as is”. We give no assurance or warranty regarding the accuracy of the contents. Readers should do their due diligence and seek the advice of an appropriately certified automotive technician before attempting any steps on this site. Original content provided by Mazda North America. The content of the manual is copyright under DMCA to: full.metal.resistor@gmail.com
LIMITATION OF LIABILITY:
We accept no responsibility for errors, inaccuracies, or omissions found on these pages. Additionally, we hereby exclude liability for any demands, claims, damages or losses of any kind with regard to any content or information provided on our web-site, including but not limited to incidental or consequential damages, direct or indirect loss, compensatory damages, loss of profits, or otherwise. By using this manual you assume full liablity for any procedures carried out on your vehicle, and are responsible for the vehicle remaining road legal and safe.