Knowledge Base

Free to use workshop manual for your 2015+ Mk4 'ND' Mazda MX-5
Home

 

< Previous   Next >

FUEL-FILLER PIPE REMOVAL/INSTALLATION [SKYACTIV-G 2.0]

WARNING:

  • Highly pressurized fuel may spray out if the fuel line is cut. Due to the following dangers occurring with a fuel spray, always complete the “Fuel Line Safety Procedure” to prevent the fuel from spraying.

    • Fuel may cause irritation if it comes in contact with skin and eyes.

    • If fuel ignites and causes a fire, it may lead to serious injury or death, and damage to property and facilities.

  • A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before draining fuel, make sure to discharge static electricity by touching the vehicle body.

CAUTION:

  • Disconnecting/connecting the quick release connector without cleaning it may cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.

1. Level the vehicle.
2. Complete the “BEFORE SERVICE PRECAUTION”. (See BEFORE SERVICE PRECAUTION [SKYACTIV-G 2.0].)
3. Open the fuel-filler lid.
4. Remove the following parts:
a. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
b. Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)
c. Partition board (See PARTITION BOARD REMOVAL/INSTALLATION.)
d. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Complete the “AFTER SERVICE PRECAUTION”. (See AFTER SERVICE PRECAUTION [SKYACTIV-G 2.0].)

Step 1

1

Fuel-filler cap

2

Bracket

Step 2 (U.S.A. and CANADA specs.)

1

Protector

2

Joint hose

(See Joint Hose Installation Note.)

3

Breather hose

(See Breather Hose Installation Note.)

4

Fuel-filler pipe

Step 2 (Except U.S.A. and CANADA specs.)

1

Protector

2

Joint hose

(See Joint Hose Installation Note.)

3

Breather hose

(See Breather Hose Installation Note.)

4

Fuel-filler pipe

Breather Hose Installation Note

1. Install the breather hose as shown in the figure.

U.S.A. and CANADA specs.

Except U.S.A. and CANADA specs.

Joint Hose Installation Note

1. Install the joint hose as shown in the figure.

< Previous   Next >
 

Free to use workshop manual for your 2015+ Mk4 'ND' Mazda MX-5

COPYRIGHT NOTICE:
This fan site is not affiliated with Mazda, and is intended for personal, or commercial use only. The content of our web pages is for general information purposes only and is presented “as is”. We give no assurance or warranty regarding the accuracy of the contents. Readers should do their due diligence and seek the advice of an appropriately certified automotive technician before attempting any steps on this site. Original content provided by Mazda North America. The content of the manual is copyright under DMCA to: full.metal.resistor@gmail.com
LIMITATION OF LIABILITY:
We accept no responsibility for errors, inaccuracies, or omissions found on these pages. Additionally, we hereby exclude liability for any demands, claims, damages or losses of any kind with regard to any content or information provided on our web-site, including but not limited to incidental or consequential damages, direct or indirect loss, compensatory damages, loss of profits, or otherwise. By using this manual you assume full liablity for any procedures carried out on your vehicle, and are responsible for the vehicle remaining road legal and safe.