Knowledge Base

Free to use workshop manual for your 2015+ Mk4 'ND' Mazda MX-5
Home

 

< Previous   Next >

SEAT BACK BAR GARNISH REMOVAL/INSTALLATION

Front

1. Affix protective tape to the shaded position shown in the figure.

2. Insert the remover tool into the notch at the position shown in the figure.

3. Move the remover tool in the direction of the arrow shown in the figure and detach hooks A and B from the back trim.
4. Detach hooks A, B and C using the remover tool and remove the seat back bar garnish.

5. Install in the reverse order of removal.

Rear

1. Remove the front seat back bar garnish. (See Front.)
2. Remove the screw.

3. Move the seat back bar garnish in the direction of the arrow and remove it while detaching the hooks.

4. Install in the reverse order of removal.
< Previous   Next >
 

Free to use workshop manual for your 2015+ Mk4 'ND' Mazda MX-5

COPYRIGHT NOTICE:
This fan site is not affiliated with Mazda, and is intended for personal, or commercial use only. The content of our web pages is for general information purposes only and is presented “as is”. We give no assurance or warranty regarding the accuracy of the contents. Readers should do their due diligence and seek the advice of an appropriately certified automotive technician before attempting any steps on this site. Original content provided by Mazda North America. The content of the manual is copyright under DMCA to: full.metal.resistor@gmail.com
LIMITATION OF LIABILITY:
We accept no responsibility for errors, inaccuracies, or omissions found on these pages. Additionally, we hereby exclude liability for any demands, claims, damages or losses of any kind with regard to any content or information provided on our web-site, including but not limited to incidental or consequential damages, direct or indirect loss, compensatory damages, loss of profits, or otherwise. By using this manual you assume full liablity for any procedures carried out on your vehicle, and are responsible for the vehicle remaining road legal and safe.