Manual pages - MX5 Manual | Mazda MX5 (Mk4) 2015+

Knowledge Base

Free to use workshop manual for your 2015+ Mk4 'ND' Mazda MX-5

< Previous Next >

NO.29 DOES NOT UPSHIFT IN M POSITION [SJ6A-EL]

29	Does not upshift in M position
DESCRIPTION	Gear position indication in instrument cluster illuminates, but the vehicle does not upshift when the selector lever is pushed to “+” side or steering shift switch “UP” is pulled.
POSSIBLE CAUSE	Up switch or related wiring harness malfunction Steering shift switch (UP) or related circuit malfunction.

Diagnostic procedure

STEP	INSPECTION		ACTION
1	Access TCM PID M_UP using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM PID/DATA MONITOR INSPECTION [TCM (SJ6A-EL)].) Monitor the PID at the selector lever is pushed to “+” side. Are PID values normal?	Yes	Go to the next step.
		No	Inspect the up switch. (See UP SWITCH INSPECTION [SJ6A-EL].) If the up switch has a malfunction: Replace the selector lever component. (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.) If the up switch is normal: Inspect for continuity the followings: Between selector lever component terminal D (up switch signal) and TCM terminal 2J. Between selector lever component terminal A and ground. Repair or replace the suspected wiring harness.
2	Access TCM PID PADDLE_UP using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM PID/DATA MONITOR INSPECTION [TCM (SJ6A-EL)].) Monitor the PID at the steering shift switch “UP” is pulled. Are PID values normal?	Yes	Inspect the instrument cluster. (See INSTRUMENT CLUSTER INSPECTION.) Replace the instrument cluster, if necessary. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
		No	Inspect the steering shift switch. (See STEERING SHIFT SWITCH INSPECTION [SJ6A-EL].) If the steering shift switch has a malfunction: Replace the steering shift switch. (See STEERING SHIFT SWITCH REMOVAL/INSTALLATION [SJ6A-EL].) If the steering shift switch is normal: Inspect for continuity the followings: Between audio control switch terminal F (steering shift switch signal) and TCM terminal 2AF. Between audio control switch terminal C (steering shift switch ground) and TCM terminal 2AB. Repair or replace the suspected wiring harness.
3	Verify test results. If normal, return to the diagnostic index to service any additional symptoms. If malfunction remains, inspect the related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis. If the vehicle is repaired, troubleshooting completed. If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM. (See TCM REMOVAL/INSTALLATION [SJ6A-EL].)

< Previous Next >

This fan site is not affiliated with Mazda, and is intended for personal, or commercial use only. The content of our web pages is for general information purposes only and is presented “as is”. We give no assurance or warranty regarding the accuracy of the contents. Readers should do their due diligence and seek the advice of an appropriately certified automotive technician before attempting any steps on this site. Original content provided by Mazda North America. The content of the manual is copyright under DMCA to: full.metal.resistor@gmail.com

We accept no responsibility for errors, inaccuracies, or omissions found on these pages. Additionally, we hereby exclude liability for any demands, claims, damages or losses of any kind with regard to any content or information provided on our web-site, including but not limited to incidental or consequential damages, direct or indirect loss, compensatory damages, loss of profits, or otherwise. By using this manual you assume full liablity for any procedures carried out on your vehicle, and are responsible for the vehicle remaining road legal and safe.