Knowledge Base

Free to use workshop manual for your 2015+ Mk4 'ND' Mazda MX-5
Home

 

< Previous   Next >

VACUUM HOSE REMOVAL/INSTALLATION

Between Power Brake Unit and Vacuum Pipe

1. Pinch open the clamp using pliers and disconnect the vacuum hose.

2. Install in the reverse order of removal. (See Vacuum hose installation note (between power brake unit and vacuum pipe).)
Vacuum hose installation note (between power brake unit and vacuum pipe)
1. Install the vacuum hose as shown in the figure.

Between Intake Manifold and Vacuum Pipe

1. Pinch open the clamp using pliers and disconnect the vacuum hose.

2. Install in the reverse order of removal. (See Vacuum hose installation note (between intake manifold and vacuum pipe).)
Vacuum hose installation note (between intake manifold and vacuum pipe)
1. Install the vacuum hose as shown in the figure.

Vacuum Pipe Cap

1. Pinch open the clamp using pliers and disconnect the vacuum pipe cap.

2. Install in the reverse order of removal. (See Vacuum pipe cap installation note.)
Vacuum pipe cap installation note
1. Install the vacuum pipe cap as shown in the figure.

Between Electric Vacuum Pump and Vacuum Pipe

1. Switch the ignition ON (engine off or on).
2. Turn the steering wheel to the right until it locks.
3. Switch the ignition off.
4. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
5. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION.)
6. Remove the front mudguard No.1 and front deflector as a single unit. (See FRONT MUDGUARD REMOVAL/INSTALLATION.)
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.

1

Quick release connector

(See Quick release connector removal note.)

(See Quick release connector installation note.)

2

Clip

3

Clamp

4

Vacuum hose

(See Vacuum hose installation note (between electric vacuum pump and vacuum pipe).)
Quick release connector removal note
1. Move the retainer tabs in the direction of arrows (1) shown in the figure, move the retainer in the direction of arrow (2).

2. Pull out the quick release connector straight from the electric vacuum pump and disconnect it.
Vacuum hose installation note (between electric vacuum pump and vacuum pipe)
1. Install the vacuum hose as shown in the figure.

Quick release connector installation note
1. Install the quick release connector as shown in the figure.

  • If the retainer cannot be pushed down, push the electric vacuum pump further to the quick release connector.

2. Lightly pull and push the quick release connector a few times by hand, and then verify that it is connected securely.
< Previous   Next >
 

Free to use workshop manual for your 2015+ Mk4 'ND' Mazda MX-5

COPYRIGHT NOTICE:
This fan site is not affiliated with Mazda, and is intended for personal, or commercial use only. The content of our web pages is for general information purposes only and is presented “as is”. We give no assurance or warranty regarding the accuracy of the contents. Readers should do their due diligence and seek the advice of an appropriately certified automotive technician before attempting any steps on this site. Original content provided by Mazda North America. The content of the manual is copyright under DMCA to: full.metal.resistor@gmail.com
LIMITATION OF LIABILITY:
We accept no responsibility for errors, inaccuracies, or omissions found on these pages. Additionally, we hereby exclude liability for any demands, claims, damages or losses of any kind with regard to any content or information provided on our web-site, including but not limited to incidental or consequential damages, direct or indirect loss, compensatory damages, loss of profits, or otherwise. By using this manual you assume full liablity for any procedures carried out on your vehicle, and are responsible for the vehicle remaining road legal and safe.